Photos

Justly Wed posted a photo:

It's hard to believe a $15K ring can start out looking like this!

adevigus posted a video:

Using the latest MC XL milling unit and the Vita CADTemp blocks you are able to mill bridgework with your CEREC system ...

Robert Gougaloff posted a photo:

The information of the bite registration scan and the ceramic abutment scan is used by the CEREC software to propose a proper provisional crown. Once approved the information is sent to the milling chamber

Robert Gougaloff posted a photo:

The ceramic abutment is powdered with contrast powder and prepared for the scan

jiattison posted a photo:

stumbled upon this on my way to the AA library...
its the DRL(design research laboratory) ten pavilion by Alan Dempsey and Alvin Huang.
more on this page - www.aaschool.ac.uk/aadrl/drlpavilion/

jiattison posted a photo:

stumbled upon this on my way to the AA library...
its the DRL(design research laboratory) ten pavilion by Alan Dempsey and Alvin Huang.
more on this page - www.aaschool.ac.uk/aadrl/drlpavilion/

jiattison posted a photo:

stumbled upon this on my way to the AA library...
its the DRL(design research laboratory) ten pavilion by Alan Dempsey and Alvin Huang.
more on this page - www.aaschool.ac.uk/aadrl/drlpavilion/

jiattison posted a photo:

stumbled upon this on my way to the AA library...
its the DRL(design research laboratory) ten pavilion by Alan Dempsey and Alvin Huang.
more on this page - www.aaschool.ac.uk/aadrl/drlpavilion/

Anthony Tammaro posted a photo:

gypsum/epoxy/silicone
Model: Amanda Bowman
Photo: Adam Wallacavage

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo:

cncinformation posted a photo: